IAI America E-Con - Manual (Page 19)

3. X-SEL-J/K/P/Q/JX/KX/PX/QX
11
(2) General-purpose type (K type)
z Either a ProfiBus-DP board or standard I/O board must be always installed in the standard slot (I/O1 --- slot
at the far left).
z The “PR1” ProfiBus-DP board occupies two expansion slots. If this type of ProfiBus-DP board is selected,
only one expansion slot can be used.
z Either an expansion I/O board *1 or SIO board *2 can be installed in an expansion slot.
Fig. 3.2
*1 Expansion I/O board
Mode [1] IA-103-X-32 (32 input points + 16 output points, NPN specification)
[2] IA-103-X-32-P (32 input points + 16 output points, PNP specification)
[3] IA-103-X-16 (16 input points + 32 output points, NPN specification)
[4] IA-103-X-16-P (16 input points + 32 output points, PNP specification)
[5] IA-IO-3204-NP (48 input points + 48 output points, NPN specification)
[6] IA-IO-3204-PN (48 input points + 48 output points, PNP specification)
[7] IA-IO-3205-NP (48 input points + 48 output points, NPN specification)
[8] IA-IO-3205-PN (48 input points + 48 output points, PNP specification)
(Note) [5] and [6] are used exclusively for the K, P and Q types, while [7] and [8] are used
exclusively for the J type.
For specification details, refer to “Operation Manual for X-SEL Controller.”
*2 SIO board
Mode [1] IA-105-X-MW-A (RS232C)
[2] IA-105-X-MW-B (RS422C)
[3] IA-105-X-MW-C (RS485C)
With all boards, one board can support two channels.
Expansion slots 1 to 3
ProfiBus-DP board
(Installed in the standard slot.)