Teledyne 9110TH - Nitrogen Oxides Analyzer - Manual (Page 108)

Model 9110TH NOx Analyzer Operating Instructions
Teledyne Analytical Instruments 88
Press the following buttons to select a communication mode for a one of the com ports,
such as the following example where HESSEN PROTOCOL mode is enabled:
Continue pressing next until …
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE EXIT
SETUP X.X SECONDARY SETUP MENU
COMM VARS DIAG ALRM EXIT
SAMPLE A1:NXCNC1=100PPM NOX=XXX.X
< TST TST > CAL SETUP
SETUP X.X COMMUNICATIONS MENU
ID INET COM1 COM2 EXIT
SETUP X.X COM1 MODE:0
SET> EDIT EXIT
SETUP X.X COM1 QUIET MODE: OFF
NEXT OFF ENTR EXIT
SETUP X.X COM1 HESSEN PROTOCOL : ON
PREV NEXT ON ENTR EXIT
SETUP X.X COM1 HESSEN PROTOCOL : OFF
PREV NEXT OFF ENTR EXIT
Continue pressing NEXT and/or PREV to select any other modes
you which to enable or disable
Use PREV and NEXT to
move between available
modes.
A mode is enabled by
toggling the ON/OFF
button.
Select which COM
port to configure
EXIT returns
to the
previous
menu
ENTR accepts the new
settings
EXIT ignores the new
settings
The sum of the mode
IDs of the selected
modes is displayed
here