CognitiveTPG DLXi - Manual (Page 35)

S T A N D A R D P R I N T E R C O M M A N D S
(n:w)
Specifications for the narrow (n)
and wide (w) bars. Place these
modifiers within parentheses.
Allowable range is 1 to 9 for both
n
and w. For UPC, EAN, ADD2,
ADD5
, and CODE128 (A, B, and C),
n
specifies an integral multiplier
for the bar code width. For all
other codes, this option specifies
the width in dots of the narrow
and wide bars. The value of w
must always be greater than n.
W
Increases the width ratio of wide
to narrow bars (use only with
CODE39
).
X
Doubles the width of all bars and
spaces in the bar code (use only
with CODE39).
x y Starting position of printed bar code. This
is the lower left corner of the bar code
block. Extender bars and bar code subtext
are below this position.
h
Height of bar code in dots. Allowable
range is 1 to 256. This does not include the
height of the bar code subtext or extender
bars (if any).
Characters ASCII characters to be bar coded.
NOTE: Not all printers support bar codes.
Refer to
Table 3. Printer Bar Code Support
for more information.
26 Revision F, January 2012, CognitiveTPG