CognitiveTPG DLXi - Manual (Page 284)

E T H E R N E T P R I N T E R I N F O R M A T I O N
Operation
Printer operation and use is as described in the user's guide, except for
the Ethernet Link Indicator described on page 268 and the printer self
test.
Self Test
To print a printer selftest label, press and hold in the FEED button
while turning the printer on. The printer should print a label showing
the NVRAM settings, including the Ethernet configuration and
physical address (MAC address) as in the following format:
Parameter Data Format
MAC Address xx:xx:xx:xx:xx:xx (hexadecimal)
IP Address ddd.ddd.ddd.ddd (decimal)
The label will show “Ethernet not Communicating” to indicate that the
printer is not operational over the network. The settings printed may
change after a DHCP initialization allows the printer to start
communicating over the network. Changing the settings manually via
SNMP or by downloading a format containing “VARIABLE
ETHERNET” commands will change the settings printed, but the
printer will not use these new settings until it has been power-cycled.
Note: Turn the printer off and back on again to clear Hex Dump mode and
resume normal operation.
Revision F, January 2012, CognitiveTPG 275