CognitiveTPG DLXi - Manual (Page 183)

P R I N T E R S E T U P
VARIABLE AUTOCUT
Function Enables or disables automatic label cutting in
printers so equipped. With automatic label cutting
enabled, the printer will cut the label after printing
the last dot row. With automatic label cutting
disabled, the printer will not cut the label unless
there is a
HALT
command in the label format.
Explicit Form
Implicit Form
VARIABLE AUTOCUT status
V AUTOCUT status
Parameters
status ON
enables automatic label cutting;
OFF
disables label cutting; ? will
return the current setting on DLX
and CSeries printers.
Comments When enabled, automatic label cutting has the
same effect as placing a HALT command in every
label format. The printer will cut and pause after
printing each label in a batch. Removing the cut
label or pressing the FEED button will signal the
printer to print the next label in the batch.
When using this command, send it to the printer
with VARIABLE WRITE in a non-printing label
format. Do not use this command in stored label
formats.
See also HALT
Example The format below will enable automatic label
cutting:
! 0 0 0 0
VARIABLE AUTOCUT ON
VARIABLE WRITE
END
174 Revision F, January 2012, CognitiveTPG