Figure 2.3-2 cu component location - internal view – Franklin Fueling Systems TS-LLD Installation Manual User Manual
Page 36
Figure 2.3-2 CU Component Location - Internal View
Control Unit Installation Steps (continued... )
2) Product Configuration (Top Jumper Link) — required only for Diesel, Fuel Oil,
or Kerosene — skip this step if gasoline will be monitored. Remove the plastic
shield in back of the control unit cover. Pull up and reposition the top blue jumper-
link at J2, so that it is installed over the left two pins. See
Figure 2.3-2 and
reinstall the plastic shield when done.
3) INCON TS-2000 Configuration (Bottom Jumper Link) — this step is required
only when the TS-LLD will be wired to or interfaced to an INCON model TS-2000
ATG console. Remove the plastic shield from the control unit cover. At J2, pull up
and reposition the bottom jumper-link so that its installed over the left two pins.
See
Figure 2.3-2 and the applicable INCON Application Note about wiring to
a TS-2000. Reinstall the plastic shield when done.
Alternate
Jum per
Link Position:
Alternate
Jum per
Link Position:
GAS
DIESEL
GAS
DIESEL
J2
J2
for Gasoline
for Diesel, or
Fuel Oils
3
2
Standard TGI
Interface
for
TS-2000 Interface
for
TS-2000 Interface
Standard TGI
Interface
Jumper Link
Side View
TS-LLD CONTROL UNIT (CU) ENCLOSURE
Alternate
Jum per
Link Position:
1
Standard
Jum per
Link Positions:
for Diesel, or
Fuel Oils
GAS
J2
for Gasoline
GAS
DIESEL
J2
DIESEL
= 1/4 inch hole
locations for
w all mounting.
1 110V
Printed Circuit
Board
(PC Board)
TB1
2 NEU
3 P-OUT
4 P-IN
SIG RTN
B O X
Donut shaped
Pickup Coil
UP
TB2
1 485A
2 485B
3 DSY1
4 DSY2
5 ALARM
F1
P L AS TIC S H IE L D S H O W N
MO U N TE D O VE R P C B O AR D .
R E M O VE TH E S H IE L D TO S E T
TH E JU MP E R L IN K P O S ITIO N
AS S H O W N B E L O W .
TH IS S H IE L D MU S T B E
IN P L AC E B E FO R E TH E
C O VE R IS R E -IN S TAL L E D .
Shield
Bo tto m Vie w
C o n tro l U n it co ve r
P C B O AR D
GAS
DIESEL
J2
J1
C O VE R (S H IE L D O FF)
G R E E N C O N N E C TO R (J1 )
G R E E N C O N N E C TO R (J1 )
C O VE R (S H IE L D O N )