Franklin Fueling Systems TS-LLD Installation Manual - Manual (Page 22)

2.2 Page 2.2 - 4 TS-LLD INSTALLATION GUIDE
5) Insert the Leak Sensing Unit into the line leak port at the pump housing. See
Figure 2.2-5, or 2.2-6, and tighten the detector with a 2 inch hex – open end
wrench (no larger than 12" long to prevent overtightening and possible pump
housing damage or leaks).
DO NOT overtighten the LSU in the pump head !
The MI Cable should be straight, vertical and able to rotate
freely with the LSU during the insertion or removal process.
Figure 2.2-5 Line Leak Detector Installation – RedJacket ® Pump Housing
NOTE
☞
PIPELINE
M I C A B L E
S TA TIO N
C O N D U IT
P U M P
HO U S IN G
L INE L E A K
D E TE C TO R
M I C A B L E
A D A P TE R