Franklin Fueling Systems TS-LLD Installation Manual - Manual (Page 17)

SAFETY Page 2.1 - 1 2.1
2.1 TS-LLD SAFETY
Important Safety Notes and Warnings
DANGER Electrical Shock Hazard. Before installing,
servicing, or working on this equipment, make sure you turn off all
submersible pump power (240 VAC) and pump relay coil /
dispenser power at the electrical panel. Tag, secure / lockout
these circuit breakers in the off position to prevent accidental or
unauthorized circuit breaker closure. Failure to turn off power
will result in severe injury or death !
DANGER Verify that no voltage exists before working-
on, or wiring-to a circuit – a lethal electrical-shock-hazard could
exist, which would kill you. Note: circuit breaker contact(s) can fail
in the on position, even when the circuit breaker lever is turned off.
DANGER The TS-LLD automatically starts the submersible
pump to run leak-tests at full line pressure between periods of
product dispensing (while the dispense switch is off). BEFORE
performing any installation or service (such as replacing fuel-
filters) – turn off / lockout all electrical power sources to the
submersible pump(s), and relieve fuel-line pressure. Failure to
turn off power, and relieve fuel-line pressure before work is started,
may cause a pressurized fuel spill. A pressurized fuel spill would
create a fire or explosion hazard that could result in injury or death.
INCON Danger stickers (see above left) are supplied with the
TS-LLD line leak detector. Apply these stickers on the pump relay
box cover, in locations near dispenser fuel-line filters, plugs,
emergency safety-shut-off valves, on the TS-LLD Leak Sensing
Unit (at the submersible pump housing), and other serviceable
components of a fuel line (where a spill would occur if the line
became pressurized). The selected surfaces must be clean, dry,
and in plain sight so that the warning can be read, and followed.
NOTE
☞
Contents:
•
Important Safety Notes and Warnings...
Read and follow these DANGER, WARNING, and CAUTION
messages before starting any installation or service.