Extron Electronics MGP 462xi Series - Manual (Page 31)

3-9 MGP Series • Operation
PRELIMINAR
Y
Auto Image menu
The Auto Image menu causes the MGP to perform an automatic image adjustment
in the selected window. Auto Image measures where the active area starts and
stops, and adjusts input sampling accordingly, so that the image fills the window.
When an input is connected, the processor measures the sync frequencies of
the incoming video source and sets the active image area, total image area, and
sampling frequency according to a table stored on the MGP. If an unknown input
is connected to the MGP, the processor measures and estimates the resolution of
the incoming video. If the processor’s estimate proves inaccurate, the Auto Image
function makes measurements to more accurately set up the input sampling.
Auto
Image
Menu
Auto Image
W1 W2 W3 W4
Use either Adjust knob
to select a submenu option.
Next
Perform Auto Image
Select the window on which
to perform an Auto Image.
Select NA to exit the menu
without performing the
Auto Image adjustment.
Default
Cycle
Next
Auto Image menu flow
To perform an Auto Image adjustment,
1
. Press the Menu button once to display the Auto Image menu.
2 . Press the Next button once to display the available option.
3 . Rotate the horizontal ( [ ) or vertical ({) Adjust knob to select the window for
which you want to perform Auto Image.
4 . Press Next again to perform the Auto Image.
5 . If desired, repeat steps 3 and 4 for any other windows for which you want to
perform an automatic image adjustment.
6 . When finished with Auto Image, do one of the following:
• Select NA and press Next.
• Press the Menu button.
• Do nothing and wait for the menu to time out.