Extron Electronics IPL Pro Series Setup Guide User Manual
Ipl pro series • setup guide, Setup checklist: how to proceed with installation

1
IMPO
RTAN
T:
Go to ww
w.extr
on.com
for the complete
user guide
, installation instructions,
and
specifications bef
ore connecting the
product to the po
wer sour
ce.
IPL Pro Series • Setup Guide
The Extron IPL Pro Series IP Link
®
Pro Control Processors integrate Ethernet connection into AV systems to allow users to
remotely control, monitor, and troubleshoot AV equipment, including display
devices and switchers. These control processors include an
embedded web server and support for
power over Ethernet (PoE). Depending on
the model, an IPL Pro control processor can
include multiple bidirectional serial ports
for use in applications that require control
and monitoring of multiple devices within a
large-scale AV system.
This guide provides instructions for an experienced installer to install an IPL Pro Series control processor and to create a
basic configuration. Configure the control processor using Extron Global Configurator software running in Global Configurator
Professional (GC Professional) or Global Configurator Plus (GC Plus) mode. The IPL integrates seamlessly with Extron
GlobalViewer
®
Enterprise (GVE) software and the GlobalViewer web-based AV resource management for remote control
applications. These control processors support multiple TouchLink
®
Pro touchpanel interfaces over a standard Ethernet network.
Global Configurator and other useful software applications are available at
.
Setup Checklist: How to Proceed With Installation
Get Ready
Familiarize yourself with the features of the control processor (see
on page 3) and of any TouchLink Pro touchpanels that will be part of the system.
Download and install the latest version of the following:
•
Global Configurator (GC) software — for setting up and configuring the control processor. GC Professional and
GC Plus modes include the
Toolbelt feature and a way to upgrade the firmware of the control processor if the need
arises.
•
IP Link Pro device drivers — for use with GC, to make control of other devices possible
•
GUI Designer software — for designing layouts for Extron TouchLink Pro touchpanels and third party touch interfaces
All are avail able fr
(see
Locating Software, Firmware, and Driver Files on the Extron Website
page 6).
Obtain network information for the unit from the network administrator. You will need the following details for each IP Link Pro
device:
DHCP setting (on or off)
Subnet mask
User name
Device (IPCP Pro, Touchlink Pro, IPL Pro) IP address
Gateway IP address
Passwords
Write down the MAC addresses of each IP Link Pro device to be used.
Obtain model names and setup information for devices the IPL will control.
Mount and Cable All Devices
Mount the unit to a rack or furniture (see
Cable devices to the control processor (see
Connect power cords and power on all the devices.
Set up the Control Processor and Touchpanels for Network Communication
Connect the PC that you will use for setup, the control processor, and touchpanels to the same Ethernet subnetwork.
For control processor LAN connections, see
Start Global Configurator and use the Toolbelt feature of the software to set the IP address, subnet, gateway IP address,
DHCP status, and related settings. See the flowchart in
Reserve this text for release with “day 2” or “day 3”
products that include these ports.
, relays, IR/serial ports, or contact input ports
Reserve this text for release with “day 2” or “day 3” products that include IR ports.
•
,
IR Learner Pro (for creating IR driver files using the remote controls
of AV products if drivers are not already available from Extron),
Document Outline
- IPL Pro Series • Setup Guide