Ocean Optics Ocean View Install - Manual (Page 94)

5: Schematic View
86 000-20000-300-02-201312
The user controls that are available vary based on which type of output control is selected.
►
Procedure
1. Wire a scalar input into the Output Control node.
2. Double-click the node to open it.
3. Select the appropriate input source for the desired property by using the drop-down menu in the
far right column of the appropriate data property. This scalar value will be sent to the
spectrometer. If no input source is selected in the drop-down menu in the right column, the
control can be adjusted manually.
4. Click on the numerical value for the desired property to reveal up/down control arrows. This
static scalar value will be sent to the spectrometer.
5. Make sure the Enabled box is checked (where applicable). Check boxes can be controlled by
wiring positive (on) or negative (off) scalar values to them.
Peak Metrics (Metrics)
Outputs the user-selected information that describes the peaks found by the Peaks node.
Location: Advanced Math -->Array Math --> Evaluate Function
Number of Inputs: 1
Type of Inputs: Peaks Node
Type of Output: array
User Controls: Check boxes to activate the output of the following values:
• Peak
• FWHM
• FWQM
• Center
• Centroid
• Integrate
• 90% Bandwidth
• Rotate Text on View Graph
Peaks (Peaks)