Ocean Optics Ocean View Install - Manual (Page 61)

4: Wizards
000-20000-310-02-201312 53
g. Note that the graph in the lower left corner of the panel populates each new data point
that is added and shows the trend line that best fits your data. If you need to remove a
point from the data table, click on that row in the table to highlight it and then click
Remove Sample Point. This point will be removed from the table and the graph.
6. Use the Regression box in the lower right corner of the panel to select between a first order
(linear) regression and a second order (quadratic) regression.
a. The Zero Intercept check box will force the trend line to pass through the point 0,0 if
selected.
b. If the Zero Intercept check box is not selected, the regression will use only the points
listed in the above data table.
7. Click Save File near the top of this panel to save your data in a new concentration (.con) file that
can be used to quickly set up this experiment in the future.
8. Click Finish to complete and exit the wizard.
Energy, Power, Photons Wizard
This wizard enables you to measure integrated intensities. Radiometric values require that you specify the
wavelength range.
►
Procedure
1. Invoke the Energy, Power, Photons wizard by clicking the Create new spectroscopy application
icon .
2. Select Energy, Power, Photons.
3. Use the Power Energy Source panel to select the absolute irradiance process used to calculate
the Energy, Power, Photons data.
4. If an absolute irradiance wizard has already been run, you can select it under Existing
processing.
--OR--
If no absolute irradiance process already exists, select New absolute irradiance processing to
begin. Complete the steps for the
Absolute Irradiance wizard before returning to complete the
Energy, Power, Photons wizard.
5. Use the Integration Settings panel to set the integration method and boundaries for the Energy,
Power, Photons data.
Peak Metrics Wizard
Create thresholds on your spectral graph to isolate peaks using the Peak Metrics Wizard.
►
Procedure
1. Invoke the Configure Peak Metrics wizard by clicking the View spectrum peaks icon .