R&M Materials Handling HOIST MONITORS - Manual (Page 89)

R&M Materials Handling, Inc.
4501 Gateway Boulevard
Springfield, Ohio 45502
P.: (937) 328-5100
FAX: (937) 325-5319
89/105
R&M Materials Handling, Inc. reserves the right to alter or amend the above information without notice.
16.7 GO –settings menu (Menu 7)
Values are equal to the ones in Menu 1 and/or Menu 2 (monitoring items). After a General
Overhaul has been performed, these parameter have to be reset to the original value (zero)
unless otherwise indicated
7 GO-setup GO-settings menu. Accessible with password level 7
Param. Name Value Description
7-1 Cycles “nnnnn” Number of hoisting cycles
7-2 MFI1 RT “nnnn” h MFI1 running time
7-3 MFI1 ST “nnnnn” MFI1 starts
7-4 MFI2 RT “nnnn” h MFI2 running time
7-5 MFI2 ST “nnnnn” MFI2 starts
7-6 RT slow “nnnn” h Run-time in slow speed
7-7 RT fast “nnnn” h Run-time in fast speed
7-8 No. OT “nnnnn” Number of hoist motor overtemperature incidents. Reset when the hoisting motor has been replaced
7-9 No. OL “nnnnn” Number of hoist overload incidents
7-10 E-stops “nnnnn” Number of emergency stops
7-11 ST up “nnnnn” Number of starts in up direction
7-12 ST down “nnnnn” Number of starts in down direction
7-13 ST fast “nnnnn” Number of starts to fast speed (two step control only)
7-14 Max ED “nn” % Maximum ED value
7-15 Over ED “nnnnn” Number of cases where ED value has exceeded the rated ED value
7-16 SRT3 “nnnnn” Load sum with hoist running time, third power
7-17 SRT8 “nnnnn” Load sum with hoist running time, eight power
7-18 SL1 “nnnnn” Load sum with hoist cycles, the first power (mean load)
7-19 SL3 “nnnnn” Load sum with hoist cycles, the third power
7-20 SL8 “nnnnn” Load sum with hoist cycles, the eight power
7-21 Power on “nnnn” h The total power on time for hoist control unit
7-22 Temp Index “nnnn” h The power on time weighted with the hoist control unit temperature
7-23 Max load “nnnn” % The maximum value of the measured load
7-24 Br Count “nnnnn”
The brake wear counter. Counts the number of stop-actions to calculate the BrSWP%. Reset when the
hoisting brake has been replaced