R&M Materials Handling HOIST MONITORS - Manual (Page 103)

R&M Materials Handling, Inc.
4501 Gateway Boulevard
Springfield, Ohio 45502
P.: (937) 328-5100
FAX: (937) 325-5319
103/105
R&M Materials Handling, Inc. reserves the right to alter or amend the above information without notice.
Appendix 7 - Replacing the condition monitoring unit
Read through all steps of these instructions and make yourself familiar with the procedure before
continuing!
Write down the following information:
Hoist’s order Number:
Hoist’s serial number:
Old unit serial number:
New unit serial number:
Fill in the requested fields of this document.
Follow the next steps to replace the Control Monitoring unit:
On the display are four pushbuttons for navigating and programming.
ESC
1. Zeroing of tare load. Press ESC button for three seconds.
2. Moving from submenu to main menu and reject parameter changes
1. Toggle between actual load (orange LED off) and tare load (orange LED on)
2. Scrolling down
1. Toggle between actual load (orange LED off) and tare load (orange LED on)
2. Scrolling up
ENT
1. Entering the password level
2. Selecting a menu and accept parameter changes
• Enter password 2180
• Read the parameter 4-7-1 value
- Push 3 times Up button => Menu 4
- Push Ent button => Menu 4-1
- Push 6 times Up button => Menu 4-7
- Push Ent button => Parameter 4-7-1
-
Check whether parameter shows Motor or Sens.
• Write down the following parameters:
- Push ESC-button 2 times => Menu 4
- Push Down-button ones => Menu 3
- Push ENT-button => Menu 3-1
- Select menu 3-2 or 3-4 whit Up-button and push ENT-button
- Read parameters’ values. Select parameter by Up- or Down-button