Printronix SL4M - Manual (Page 244)

244
Appendix B Using the Full Media Rewinder Option
Figure 13. Media Rewind Path
NOTE: The alternate media path is for inside wound label.
3. Loosen the thumbscrew, pull it outward, position the wind direction lever
in the desired location, and tighten the thumbscrew. See Figure 13.
NOTE: Wind direction lever in lower position = clockwise rotation.
Wind direction lever in upper position = counterclockwise rotation.
IMPORTANT If you do not complete the following step, it will be extremely difficult to
remove the printed labels from the rewinder.
4. Remove the media rewinder clip.
5. Wrap the leading edge of the media around the rewinder.
6. Slide the media flush against the left edge of the rewinder.
Media
Media
Guide
Media Guide
Roller
Rewinder
Frame
Opening
Alternate
Media Path
Thumbscrew
NOTE: The wind direction lever
(not shown) is located behind
the thumbscrew.
Rewinder Full
Sensor
Alternate Rewind Path
Sensor
Thumbscrew