Printronix SL4M User Manual
Page 201
Fault Messages
201
ERROR: INSUFFICIENT
DRAM
Cycle Power
Yes/No
Not enough RAM
memory available for a
printer function.
1.
Power off the printer for
15 seconds, then power
back on again.
2.
If the message
reappears, delete files
from FFS as they are
copied into RAM.
3.
Select the menu option,
Optimize & Reboot.
4.
If the message
reappears, replace the
controller PCBA. Write
down the message and
return it with the
defective board.
ERROR: INSUFFICIENT
FLASH
Cycle Power
Yes
The printer requires
more flash memory to
run the downloaded
program.
1.
Power off the printer for
15 seconds, then power
back on. If the problem
persists, contact your
authorized customer
service representative.
2.
Consider installing an
optional Expanded
Memory Cartridge
(EMC) that adds 32 MB
of Flash memory to the
printer.
ERROR OCCURRED:
CLEARING QUEUES
Please Wait
Yes
An interim message
displays while the
printer discards host
data it cannot use
because a fault
condition exists. While
this message displays,
the asterisk (*) rotates.
Wait. When the asterisk (*)
stops rotating, a different
fault message will appear;
troubleshoot the final
message.
ERROR: PROGRAM
NEEDS MORE DRAM
Yes/No
The program exceeds
the memory limitations
of the printer.
Download a smaller
program.
Table 15. Fault Messages
Displayed Message
Can User
Correct?
Explanation
Solution