Printronix SL4M - Manual (Page 236)

236
Appendix B Copying the QCMC “Snapshot” Image to a Second Printer
This means that the printer’s hardware options do not match the original
printer’s options.
A QCMC validation check will be performed to ensure the data stored on the
EMC is not corrupted. If the test fails the following fault message will display.
This means that the data on the QCMC was not saved properly, and must be
deleted then resaved. Follow the instructions for deleting files, then repeat the
copying process.
If all the checks pass, then the printer will copy the files from the QCMC to the
target printer.
Upon successful completion, the printer will display the following message on
the front panel and reboot into normal operation. Once the printer boots
Online, it is necessary to select a “Run Auto-Cal” option located under the
“Sensor Setup” menu.
PRINTER HARDWARE
NOT COMPATIBLE
Power Off Printer
Remove Cartridge
QCMC DATA ERROR
ON EMC
Delete & Resave
QCMC Data
DO NOT PWR OFF
Copying QCMC To
Printer...
XX%
Copy Complete
Run Auto-Cal
After Reboot