Printronix SL4M User Manual
Page 163
163
16. Once logged in, type the following sequence at the command prompt to
download the
filename
.prg file to the printer:
cd dest
cd d1prn
bin
put filename.prg
where
filename
.prg is the file name you noted in step 8.
IMPORTANT
Do not interrupt the downloading process once it has started.
Interrupting a download will leave the flash memory on the controller
PCBA and NIC incompletely loaded, and the printer may not boot up.
17. When the download is complete, exit the FTP program by typing:
quit
18. When the new software has successfully loaded into flash memory and
the printer has reset itself, set the printer power switch to O (Off).
19. Remove the CD from the host computer and store it with the printer.
20. If required, reconnect the data input cable(s) to the printer.
21. Set the printer power switch to | (On).
22. Using the configuration printout(s) you made in step 1 on page 162,
restore the printer configurations.