Printronix SL4M - Manual (Page 205)

Fault Messages
205
Half Speed Mode Yes The printhead is
approaching a hot
state. Half Speed Mode
helps the cooling
process and should
permit completion of
print jobs.
Half Speed Mode helps
prevent a PRINT HEAD
HOT fault, which will
stop the printer. 1. Allow printer to continue
printing. Full speed will
resume automatically
when a lower printhead
temperature is achieved.
2. Let the printer cool
down. Full speed will be
restored when printing is
resumed.
3. Lower Print Intensity and
Print Speed to reduce
frequency of Half Speed
Mode.
ILL NVM VALUE 5
ILL NVM VALUE 6
ILL NVM VALUE 7 Yes Printer firmware code
error. 1. Cycle Power. Run the
print job again. If the
message appears, load
the latest emulation
software.
2. Cycle power. Run the
print job again. If the
message appears,
record the display
message and follow the
instructions on page 186
3. Contact your authorized
customer service
representative.
INVALID EMC
Power off Printer
Remove Cartridge
Yes The QCMC is not
compatible with the
software in the printer. Upgrade printer software.
INVALID FILE SYS
Optimize&Reboot
Yes File system not
detected or flash was
corrupted. Enter the PRINTER SETUP
menu and use the Optimize
& Reboot option.
Table 15. Fault Messages
Displayed Message
Can User
Correct?
Explanation Solution