Printronix SL4M User Manual
Page 207

Fault Messages
207
LOADING PROGRAM
FROM PORT XX%
Yes
The new emulation
program is loading into
printer RAM. XX%
indicates how much of
the program has
loaded.
No action required.
LOADING PROGRAM
INTO FLASH
Yes
A program is getting
loaded into flash.
No action required.
MEMORY REMOVED
Check EMC
Yes
The EMC was removed
while the printer was
powered on.
1.
Power off the printer.
2.
Install the EMC.
3.
Power on the printer.
MEDIA OUT
Load Media
Yes
The printer does not
sense media:
•
Media was not
installed or has run
out.
•
A break in media
has occurred.
•
Media was not
routed or installed
correctly.
•
The media sensor
is not positioned
correctly.
•
Media is installed
correctly, but the
sensor is not
detecting it.
•
Gap/Mark Thresh
value may be set
too high and/or
Paper Out Thresh
may be set too low.
1.
Install media. If a break
occurred, reinstall the
media. Press the Pause
key to clear the fault
message. Check the
media installation
procedures on page 25.
2.
Verify the media sensor
is properly positioned.
Run Auto-Cal to improve
the ability of the sensor
to detect the installed
media.
3.
Check if the Gap/Mark
Thresh is too high or the
Paper Out Thresh is too
low. Lower the Gap/
Mark Thresh or raise the
Paper Out Thresh value.
4.
If using media with no
gaps or black marks,
perform Run Auto-Cal to
establish a valid Paper
Out Thresh.
Table 15. Fault Messages
Displayed Message
Can User
Correct?
Explanation
Solution