Printronix SL4M - Manual (Page 209)

Fault Messages
209
NVM HDW FAIL 8 Yes Printer firmware code
error. 1. Cycle Power. Run the
print job again. If the
message appears, load
the latest emulation
software.
2. Cycle power. Run the
print job again. If the
message appears,
record the display
message and follow the
instructions on
page 186.
3. Contact your authorized
customer service
representative.
OPTION
NOT INSTALLED
Yes 1. Selection of
Peel-Off, Cut, or
Rewind Media
Handling was
attempted when the
option was not
properly installed.
2. The printer is
powered on with
the cutter not
connected
correctly.
1. Check that the correct
selection was attempted
and that the option is
installed.
2. Check that the
appropriate option is
installed and connected
correctly before
powering on the printer.
3. If the error persists,
contact your authorized
customer service
representative.
PGL ERROR Yes Appears when the
"Fault" option is
selected from Error
Report in the front
panel. Deselect "Fault" from Error
Report on the front control
panel.
PRINT HEAD UP
Close Print Head
Yes Printhead is not closed. Close the printhead pivoting
deck.
Table 15. Fault Messages
Displayed Message
Can User
Correct?
Explanation Solution