beautypg.com

Printronix P8000 Series Cartridge Ribbon Printer User Manual

Page 408

background image

408

Requirements

power, 19

printer site, 19

Reset Cfg Names, 92

Reset Cmd CFG Ld, 145

ANSI Emulation menu, 171

Reset Cmd CFG Ld, PCL-II Emulation, 206

Resolution, 87, 212

Resp. Polarity

Centronics (Parallel) submenu, 99

RESTORING BOOT CODE message, 305, 324

Ret. Status Port, ADVANCED USER Menu, 235

RIB INVLD CMD* message, 305

Ribbon Cartridge Specifications

ASCII, 327

HD, 327

H-Series, 327

Ribbon Cartridge, changing, 50

Ribbon End Point, 90

Ribbon End Point, PRINTER CONTROL, 217

RIBBON STALL message, 305

RIBBON UNDER 2% message, 306

Rot. Char Size, 189

RS-232

Clear to Send (CTS), 246

Data Carrier Detect (DCD), 246

Data Set Ready (DSR), 246

Data Terminal Ready (DTR), 246

Receive Data (RD), 246

Request to Send (RTS), 246

Transmit Data (TD), 246

RS-232 Serial Interface, 245

Run Demo File, 280

S

Save Config, 90, 91

Save, Auto, 62

Saving new configurations, 63

Saving parameter settings, 54

Saving Printer’s Configuration, Quick Change

Memory Cartridge (QCMC), 357

Scalable Size, 181

SCS COMMAND ERROR message, 325

SD CARD ERROR message, 306, 325

SD Card, download files to, 276

SD FILE EXISTS message, 306

SD File System, ADVANCED USER Menu, 233

SD FILESYS FULL Delete Files message, 306

SD FILESYS FULL File Too Big message, 306

SD FILESYS WRITE message, 306

SD INSERTED message, 306

SD NOT FOUND message, 306

SD READING message, 306

SD REMOVED message, 306

SD WRITE FAIL WRITE PROTECTED

message, 307

SD WRITING message, 307

SDSC CARD NOT SUPPORTED

message, 307, 325

Second Char. Set, PCL-II Emulation, 204

SECURITY KEY NOT DETECTED

message, 307, 325

SECURITY VIOLATION message, 307, 325

Select CPI, 84

Select Downloaded TrueType Fonts, 279

Select Font, 177, 183

SELECT key, 30

Select LPI, 84, 177

Select SO Char, 179

Sending Firmware in Download Mode, 264

ethernet (LPR), 264

Parallel, 270

Serial, 271

USB, 264

Serial Interface, RS-232, 245

Serial Matrix Character Set menu, 158

Serial Matrix Emulation, 155

Alt. Set 80-9F, 157

Autowrap, 156

Character Set, 157

Control Code 06, 156

Define CR Code, 156

Define LF Code, 156

ESC d command, 157