Printronix P8000 Series Cartridge Ribbon Printer - Manual (Page 295)

Printing a Hex Dump
295
D50 STATUS
UPGRADING PANEL
No Status message: The
printer is upgrading the
panel, where %XX
represents the
percentage completed. No action is required.
D51 STATUS
PROGRAMMING DONE
No Status message: The
printer is loading
firmware, where %XX
represents the
percentage completed. No action is required.
DIAGNOSTIC PASSED No Status message: the
printer passed its
memory and hardware
initialization tests.
No action is required.
DO NOT POWER OFF No Status message: The
printer is performing an
operation that must be
completed before you
can cycle power. No action is required, but do
not power off the printer until
the operation is complete.
DP FIFO Busy* Yes There is a timing problem
in the Engine Controller
firmware. 1. Cycle power. Run the
print job again. If the
message appears,
download the emulation
software again.
2. Cycle power. Run the
print job again. If the
message appears again,
contact your authorized
service representative.
1
Table 23. LCD Message Troubleshooting Table (ASCII)
Displayed Message
Can User
Correct?
Explanation Solution
Fault Messages (ASCII in Alphabetical Order)