Printronix P8000 Series Cartridge Ribbon Printer - Manual (Page 304)

304
Chapter 8 Fault Messages (ASCII in Alphabetical Order)
PRINTER UNDER REMOTE
CONTROL No Status message: The
printer is under the
control of PrintNet
Enterprise (PNE) remote
management software. No action is required.
PROCESSOR HALTED
EC_FAULT_RTSYS2 No Real-time System
Firmware error on
controller board. Contact your authorized
service representative.
1
PROTECTED INSTR* No Protected Instruction.
Firmware error on
controller board. Contact your authorized
service representative.
1
PS/PDF ERROR:
CHECK ERROR Yes Fault displayed when
Postscript/PDF failed to
process a job. One or
more of the following
errors were detected:
Type Check, Limit Check,
Range Check, or No
Current Point Defined. Check the Postscript/PDF job
for syntax (Postscript) errors.
Clear the fault. Postscript/PDF
will continue with the next job.
PS/PDF ERROR:
DICTIONARY ERROR Yes Fault displayed when
Postscript/PDF failed to
process a job. One or
more of the following
errors were detected:
Dictionary Full, Dictionary
Stack Overflow, or
Dictionary Stack
Underflow. Check the Postscript/PDF job
for syntax (Postscript) errors.
Clear the fault. Postscript/PDF
will continue with the next job.
PS/PDF ERROR:
INVALID ACCESS Yes Fault displayed when
Postscript/PDF failed to
process a job. One or
more of the following
errors were detected:
Invalid Access, Invalid
Font, or Invalid Exit. Check the Postscript/PDF job
for syntax (Postscript) errors.
Clear the fault. Postscript/PDF
will continue with the next job.
PS/PDF ERROR:
I/O ERROR Yes Fault displayed when
Postscript/PDF failed to
process a job. One or
more of the following
errors were detected: I/O
Error, Invalid File Access,
Undefined File, Interrupt,
or Time Out. Check the Postscript/PDF job
for syntax (Postscript) errors.
Clear the fault. Postscript/PDF
will continue with the next job.
Table 23. LCD Message Troubleshooting Table (ASCII)
Displayed Message
Can User
Correct?
Explanation Solution