Printronix P8000 Series Cartridge Ribbon Printer - Manual (Page 302)

302
Chapter 8 Fault Messages (ASCII in Alphabetical Order)
LOADING PROGRAM
FROM PORT XX% No Status message: the new
emulation program is
loading into printer RAM.
XX% indicates how much
of the program has
loaded. No action is required.
LOADING PROGRAM INTO
FLASH No The printer has deleted
the previous program
from flash memory and is
loading the new program
into flash memory. No action is required.
NEW SPX DETECTED
PRESS ENTER
No The printer detects an
SPX installed at the
debug port and the SPX
is valid for the printer. Contact your authorized
service representative. 1
NON VOLATILE MEMORY
FAILED No Large emulations reduce
the amount of space
available for saving
configurations, which
means that sometimes
fewer than eight
configurations can be
saved. Contact your authorized
service representative. 1
ONLINE N/A Printer state message:
printer is online and in
communication with host. No action is required.
PANEL
BAD CHECKSUM
No Panel Code has a bad
Checksum. Reload released firmware.
PAP BAD TABLE* No Paper Bad Table. The
paper feed process on
the controller board has a
corrupted table. Contact your authorized
service representative.
1
PAP FD DRVR CIR*
See Manual
No Paper Feed Driver
Circuit. The paper feed
driver circuit on the
controller board is
drawing too much
current. Contact your authorized
service representative.
1
PAP FIFO OVERFL* No Paper First In First Out
Overflow. Firmware error
on controller board. Contact your authorized
service representative.
1
PAP FIFO UNDRFL* No Paper First In First Out
Underflow. Firmware
error on controller board. Contact your authorized
service representative.
1
Table 23. LCD Message Troubleshooting Table (ASCII)
Displayed Message
Can User
Correct?
Explanation Solution