Printronix P8000 Series Cartridge Ribbon Printer - Manual (Page 301)

Printing a Hex Dump
301
ILL NVM VALUE 5
ILL NVM VALUE 6
ILL NVM VALUE 7 Yes Illegal value was stored
into the Novram module. 1. Cycle power. Run the
print job again. If the
message appears, load
the latest emulation
software.
2. Cycle power. Run the
print job again. If the
message appears again,
record the exact display
message, follow the
instructions on page 290,
“Diagnostics for EXX,
BAD NVM, or ILL NVM
Errors”, and contact your
authorized service
representative.
1
ILLGL OPR ACCSS* No Illegal Operand
Accessed. Firmware
error on controller board. Contact your authorized
service representative.
1
INITIALIZING... Yes This message indicates
the printer is beginning its
initialization process. No action is required.
INTAKE FAN CHECK Yes Sensor cannot detect
current in fan circuit. Cycle power. If the message
appears, press CLEAR. If the
message does not clear,
contact your authorized
service representative.
1
INTERRUPT UNUSED
VECTOR 00 No The controller board
receives an interrupt it
does not understand. The
problem can be created
by electrical noise, by a
software problem, or by a
hardware problem. Cycle power. If this message
occurred once and never
again, you can ignore it. If the
message reappears or
appears consistently, contact
your authorized service
representative.
1
LO DRV. SHORT * No Lower Driver Short.
Circuit(s) on the hammer
bank or in the hammer
bank power cable
shorted to ground. Contact your authorized
service representative.
1
LOAD PAPER Yes Printer is out of paper. Load paper and press
CLEAR.
Table 23. LCD Message Troubleshooting Table (ASCII)
Displayed Message
Can User
Correct?
Explanation Solution
Fault Messages (ASCII in Alphabetical Order)