Printronix P8000 Series Cartridge Ribbon Printer - Manual (Page 297)

Printing a Hex Dump
297
E-Net Test Unavailable Yes The ethernet did not
initialize correctly. Cycle power. Wait for “E-Net
Ready” to display, then retry
operation. If it still fails, contact
your authorized service
representative.
1
ERROR OCCURRED
FLUSHING QUEUES* Yes An interim message that
displays while the printer
discards host data it
cannot use because a
fault condition exists.
While this message
displays, the asterisk (*)
rotates. Wait. When the asterisk (*)
stops rotating, a different fault
message will appear:
troubleshoot the final
message.
ERROR NOR FLASHED
WAS
NOT CLEARED
No Problem programming
Boot Code. Contact your authorized
service representative. 1
ERROR: DC PROGRAM
NOT VALID Yes The printer cannot find
the data controller
program or the validation
checksum is corrupt. Download the program again.
If the message appears,
contact your authorized
service representative. 1
ERROR: LOCKED
SN=nnnnnnnnnnnnnnnnnnnn
n No nnnnnnnnnnnnnnnnnnnn
n is the serial number of
the printer’s security key.
The SPX serial number
does not match the
printer’s serial number
and cannot be used with
the printer. Contact your authorized
service representative.
1
ERROR: NVRAM FAILURE No The non-volatile SRAM
on the controller board
has failed. Contact your authorized
service representative. 1
ERROR: PROGRAM NOT
COMPATIBLE Yes The printer is not
compatible with the
downloaded program. Use the correct emulation
software options(s) for this
printer model.
ERROR: PROGRAM NOT
VALID Yes The printer does not see
a program in flash
memory. There is no program in printer
memory. Download the
emulation.
ERROR: SECURITY KEY
NOT DETECTED No The security key is not
present or failed. Contact your authorized
service representative. 1
ERROR: WRONG
CHECKSUM No The printer received the
complete program but the
checksum did not match.
The data may have been
corrupted during
downloading. Contact your authorized
service representative.
1
Table 23. LCD Message Troubleshooting Table (ASCII)
Displayed Message
Can User
Correct?
Explanation Solution
Fault Messages (ASCII in Alphabetical Order)