Printronix P8000 Series Cartridge Ribbon Printer - Manual (Page 147)

P-Series Emulation
147
P-Series Emulation
Control Code 06
Control Code 06 defines the function of ASCII code hex 06 (ACK). You can
select an alternate line spacing of 6, 8, or 10.3 LPI.
Control Code 08
Control Code 08 defines the function of ASCII code hex 08 (BS). You can
define the code to output the following character:
• Elongated (factory default).
• Backspace .
Define CR Code
This option controls the action of the printer when it receives a Carriage
Return code (hex 0D) from the host computer. If this feature is enabled, each
time the printer receives a carriage return, it inserts an additional Line Feed
code (hex 0A) into the data stream. Do not use this feature if the host
computer sends Line feeds to the printer.
• CR = CR (factory default). Does not insert an extra line feed after each
carriage return.
• CR = CR + LF . Inserts an extra line feed after each carriage return. The
next print position will be print position 1 of the next line.
Printer
Protocol
(from page 125)
Control Code
06
Control Code
08
Define CR
Code
Autowrap Overstrike Define LF
Code
P-Series
SFCC
VFU Select Alt. Set
80-9F
Character
Set
SFCC d
Command
PSeries Dbl
High
8.0 LPI*
10.3 LPI
6.0 LPI
Elongated*
Backspace
CR = CR*
CR = CR + LF
Wrap LF+CR*
Wrap CR
Disable
Enable*
Disable
LF = CR + LF*
LF = LF
1*
(0-7F hex)
EVFU*
DVFU
CVFU
Disable
Control Code*
Printable
(see page 150) Even dot plot*
Double high
Normal*
P3/4/6/9 Compat
* = Factory Default
P-Series
FF valid
at TOF
Enable*
Disable