Printronix P8000 Series Cartridge Ribbon Printer - Manual (Page 200)

200
Chapter 4 EMULATION Menu
Graphics Scaling
This parameter chooses the scaling factor for graphics when the Mapping
Control option of the IPDS Write Graphics Control command is SCALE TO
FIT:
• Rounded (factory default). Calculations are rounded up in the desired
output resolution.
• Exact . Graphics will be scaled as accurately as possible.
Graphic CharSize
This parameter will emulate the graphic character size of the selected printer
model.
• 4234 (factory default). IBM 4234
• 67XX . Decision Data 67XX
I2/5 Checksum
This parameter defines the printer checksum calculation method for
Interleaved 2 of 5 barcodes.
• Standard (1/3) (factory default). The odd numbers will be multiplied by 3
and the even numbers by 1 for calculation of the checksum.
• Special (4/9) . The odd numbers will be multiplied by 4 and the even
numbers by 9 for calculation of the checksum.
NOTE: “Odd” refers to the 1st, 3rd, 5th... character in the barcode, while
“even” refers to the 2nd, 4th, 6th... character in the barcode.
Default Code Page
Choose which code page to use with the IPDS emulation.
Code Page Subset
When the Thai code page is selected as the default, either from the front
panel or by a host command, you may choose from three different versions.
Default Font
Choose a font quality and size from the available selections. All fonts in the
Default Font menu are available in standard and compressed vertical
resolution (see page 197).
VPA Check
• Enable (factory default). The printer checks for dots that fall outside the
intersection of the logical and physical pages. If dots fall outside the area,
the printer reports an error to the host if the IPDS Exception Handling
Control command setting requires error reporting.
• Disable . The printer does not report dots outside the valid printable area.