Page format submenu (h-series) printer protocol, Cpi/lpi select, Host command – Printronix P8000 Series Cartridge Ribbon Printer User Manual
Page 137
LinePrinter Plus Emulation (H-Series Hangul)
137
Page Format Submenu (H-Series)
Printer Protocol
Select the LinePrinter+ protocol you wish to use. Refer to the
LinePrinter Plus
Programmer's Reference Manual
for more information with ASCII products.
For H-Series Hanzi GB, Hanzi Big5, or Kanji LP+ printers, refer to the
LQ-1600K Programmer’s Reference Manual
for details. For the H-Series
Hangul LP+ printer, refer to the
KS
or
KSSM Programmer’s Reference
Manual
for details.
CPI/LPI Select
This parameter lets you specify the characters per inch (cpi) and lines per
inch (lpi) values.
Host Command
This parameter allows you to block certain host commands from being
acknowledged by the printer.
•
Enable
(factory default). All host commands are acknowledged by the
printer.
•
Ignore All
. All host commands are ignored by the printer.
•
Ignore CPI
. All CPI commands sent by the host are ignored by the
printer.
•
Ignore LPI
. All LPI commands sent by the host are ignored by the printer.
•
Ignore Unidir
. All Unidirectional commands sent by the host are ignored
by the printer.
•
Ignore Pg. Fmt
. All page format commands sent by the host are ignored
by the printer. This is applicable for H-Series Hangul LP+ printers only.
Page Format
(from page 126,
Margins
Left Margin
0* columns
(0-369)
Right Margin
0* columns
(0-369)
Bottom Margin
0* lines
(0-451)
* = Factory Default for Hanzi and Hangul printer
** = Factory Default for Kanji printer
Perforation
Skip
Disable*
1/2 inch
2/3 inch
5/6 inch
1 inch
Form
Length
Abs. Length IN
11.0* inches
08.5** inches
(0.1-24)
Abs. Length MM
279.4* mm
215.9** mm
(0.1-609.6)
Funct. of Lines
66* Lines
68** Lines
(1-192)
Form
Width
Abs. Width IN
13.6* inches
(0.1-13.6)
Abs. Width MM
345.4* mm
(0.1-345.5)
Funct. of CPI
136* Characters
204** Characters
(1-272)
Page Format Submenu (H-Series)