Printronix P8000 Series Cartridge Ribbon Printer - Manual (Page 160)

160
Chapter 4 EMULATION Menu
Proprinter XL Emulation
Define CR Code
This option controls the action of the printer when it receives a Carriage
Return code (hex 0D) from the host computer. If this feature is enabled, each
time the printer receives a Carriage Return, it inserts an additional Line Feed
code (hex 0A) into the data stream. Do not use this feature if the host
computer sends line feeds to the printer.
• CR = CR (factory default). Does not insert an extra line feed after each
carriage return.
• CR = CR + LF . Inserts an extra line feed after each carriage return.
Autowrap LF
This option defines the printer action when print data is received past the
forms width setting.
• With LF+CR (factory default). Performs an automatic carriage return and
line feed when data is received past the forms width.
• With CR . Performs an automatic carriage return (without line feed) when
data is received past the forms width.
• Disable . Discards any data past the forms width.
Define LF Code
• LF = LF (factory default). Does not perform an automatic carriage return
when a Line Feed command is received. The next print position will be
the current print position of the next line.
• LF = CR + LF . Forces an automatic carriage return with each Line Feed
command received. The next print position is print position 1 of the next
line.
Printer
Protocol
(from page 125)
Define CR
Code
Autowrap Define LF
Code
FF valid at
TOF
Character
Set
Alt. Char
Set
20 CPI
Condensed
CR = CR*
CR = CR + LF
With LF+CR*
With CR
Disable
LF = LF*
LF = CR + LF
Enable*
Disable
(see page 162) Set 1*
Set 2
Enable*
Disable
* = Factory Default
Proprinter
XL