Printronix P8000 Series Cartridge Ribbon Printer - Manual (Page 305)

Printing a Hex Dump
305
PS/PDF ERROR:
JOB ABORTED Yes Fault displayed when
Postscript/PDF failed to
process a job, e.g. an
unsupported command or
a large job which requires
more DRAM to process. Clear the fault. Postscript/PDF
will continue with the next job.
PS/PDF ERROR:
STACK ERROR Yes Fault displayed when
Postscript/PDF failed to
process a job. One or
more of the following
errors were detected:
Stack Overflow, Stack
Underflow, Exec Stack
Overflow, or Invalid
Restore. Check the Postscript/PDF job
for syntax (Postscript) errors.
Clear the fault. Postscript/PDF
will continue with the next job.
PS/PDF ERROR:
SYNTAX ERROR Yes Fault displayed when
Postscript/PDF failed to
process a job. One or
more of the following
errors were detected:
Syntax Error, Unmatched
Mark, Undefined,
Undefined Results, or
Unknown Error. Check the Postscript/PDF job
for syntax (Postscript) errors.
Clear the fault. Postscript/PDF
will continue with the next job.
PWR SUPP VOLT * No Power Supply Voltage.
The power supply has
failed. Replace power supply board.
REMOVE USED SPX
THEN PRESS ENTER
No Status message: An SPX
is depleted because it
has successfully
reprogrammed the
security key on the
controller board. Contact your authorized
service representative. 1
RESTORING BOOT CODE No Normal download
initialization message. No action is required.
RIB INVLD CMD*
See User Manual
Yes Ribbon Invalid
Command. Firmware
error on the controller
board. Cycle power. Run the print job
again. If the message
appears, download the
emulation software again. If
the message appears again,
contact your authorized
service representative. 1
RIBBON STALL Yes The controller board does
not detect ribbon
movement. Check the ribbon path for
jams. Turn the Ribbon Tension
Knob clockwise a few
rotations. If necessary, install
a new ribbon.
Table 23. LCD Message Troubleshooting Table (ASCII)
Displayed Message
Can User
Correct?
Explanation Solution
Fault Messages (ASCII in Alphabetical Order)