TROY Group MICR_IRD 9000 1UP MICR Printing Solutions User’s Guide - Manual (Page 23)

Section 2 Understanding TROY’s Features
MICR Solutions User’s Guide -- Document #50-70341-001 Rev. F
2-10
Automatic Print
Density Each time the printer is switched to MICR mode enabled, the print density is automatically set to a pre-
determined value required for MICR printing. If the user changes the density setting to accommodate a non-
MICR print job, the density will automatically return to the pre-determined MICR value when the printer is
switched back to MICR mode enabled.
NOTE: You can change the density setting; however, the printer will ignore the setting and use the pre-determined
MICR setting when printing MICR documents. TROY does not support any density setting other than the pre-
determined MICR density value.