Ohaus I150-S Indicator - Manual (Page 62)

62
Storing Tare Values With ID Codes: Storing Tare Values With ID Codes: Storing Tare Values With ID Codes: Storing Tare Values With ID Codes: Storing Tare Values With ID Codes:
NOTE: TARE must be selected for the
STORE parameter in the scale submenu.
1. Enter a tare value ( see “Taring”)
2. Enter an ID code (up to six digits)
using the numeric keypad
3. Press FNCT , then STORE .
The ID code and tare will be stored to-
gether. Repeat the procedure as needed
for up to ten ID codes and tare values.
Using Stored Tare Values: Using Stored Tare Values: Using Stored Tare Values: Using Stored Tare Values: Using Stored Tare Values:
1. Place a load on the load receiver.
2. To recall a stored ID and tare value:
Enter the desired ID code using the
numeric keypad, then press RECL .
The display will show the net weight. To
change to a different ID and tare, repeat
the procedure using a new ID code.
Storing Average Piece Weights With Storing Average Piece Weights With Storing Average Piece Weights With Storing Average Piece Weights With Storing Average Piece Weights With
ID Codes:
ID Codes: ID Codes: ID Codes: ID Codes:
NOTE: APW must be selected for the
STORE parameter in the scale submenu.
LFT NOTE: LFT NOTE: LFT NOTE: LFT NOTE: LFT NOTE: APW is not available with
LFT ON.
1. Enter an average piece weight (see
“Parts Counting”)
2. Enter an ID code (up to six digits)
using the numeric keypad
3. Press FNCT , then STORE .
The ID code and average piece weight will
be stored together. Repeat the procedure
as needed for up to ten ID codes and
average piece weights.
Enter ID Code up to 6 digits,
Press FUNCTION then STORE.
Enter stored ID Code,
Press RECALL.
FUNCTION FUNCTION FUNCTION FUNCTION FUNCTION
FUNCTION FUNCTION FUNCTION FUNCTION FUNCTION
STORE STORE STORE STORE STORE
RECALL RECALL RECALL RECALL RECALL
STORE STORE STORE STORE STORE
RECALL RECALL RECALL RECALL RECALL
STORE STORE STORE STORE STORE
RECALL RECALL RECALL RECALL RECALL