Ohaus I150-S Indicator - Manual (Page 24)

24
To select a parameter:
Repeatedly press UPUP or DOWN
until it is displayed,
then press ENTER .
SCALE SUBMENUMENU SCALE SUBMENUMENU SCALE SUBMENUMENU SCALE SUBMENUMENU SCALE SUBMENUMENU
The Scale submenu is used to view or change the parameters outlined in the following
table. The table shows the sequence in which the parameters are displayed on the
I150.
SCALE SUBMENU SCALE SUBMENU SCALE SUBMENU SCALE SUBMENU SCALE SUBMENU
Displayed Parameter Displayed Parameter Displayed Parameter Displayed Parameter Displayed Parameter Description Description Description Description Description
sets parameters below to defaults
specifies the averaging level
specifies the stability range
specifies which weighing units will be
available during weighing operations
sets Auto-Zero Tracking on or off
enables entering custom weighing unit
specifies number of sample weighings
to be averaged in animal weighing mode
specifies an allowable percentage of
error for parts counting results
sets indicator for checkweighing, filling
or emptying operations
used to enter PREACT and DRIBBLE
weights for filling/emptying operations
specifies tare, average piece weight, or
in-out values for storage with ID codes
specifies if zero data is permanently
stored every time indicator is zeroed
used to exit scale submenu
* Does not appear in submenu when configured for Legal For Trade
** Only appears in submenu when “FiLL” or “UnFiLL” is selected in “SEt Pt”
*
*
*
**
ENTER ENTER ENTER ENTER ENTER