Ohaus I150-S Indicator - Manual (Page 3)

3
PREFACE PREFACE PREFACE PREFACE PREFACE
The I150 Electronic Indicator is a highly versatile device which is designed for a variety
of applications. It can be used with virtually any load receiver which provides a
compatible output signal. This instruction manual contains the information needed to
install, configure and operate the I150. Read it before attempting to operate the
indicator.
The I150 is a software controlled indicator with a host of user-programmable features.
Calibrating and setting up operating parameters are easily accomplished using the
front panel keypad and display. These are a few of the standard features included with
the indicator:
RS-232 Interface: RS-232 Interface: RS-232 Interface: RS-232 Interface: RS-232 Interface: The bi-directional RS-232 interface enables the indicator to
communicate with printers and computers. Instructions on connecting and using the
interface are included in this manual.
Parts Counting: Parts Counting: Parts Counting: Parts Counting: Parts Counting: The parts counting feature allows you to count parts in a number of
ways. You can enter the average piece weight and start counting, or let the indicator
perform averaging and display the count.
Single/Dual Platform Operation: Single/Dual Platform Operation: Single/Dual Platform Operation: Single/Dual Platform Operation: Single/Dual Platform Operation: The I150 is a two-channel indicator which permits
you to monitor two load receivers. Switch to either load receiver by pressing a single
button.
Checkweighing and Filling: Checkweighing and Filling: Checkweighing and Filling: Checkweighing and Filling: Checkweighing and Filling: Set point indicators and digital outputs are provided for
these applications. In checkweighing, the indicators and digital outputs correspond to
OVER, UNDER and ACCEPT values. In filling processes, they can be used to activate
preset feedrates and cutoff points of filling devices.
Classifications Classifications Classifications Classifications Classifications
Both models I150-P and I150-S have been tested and certified to comply with the
following regulations:
Weights and Measures Weights and Measures Weights and Measures Weights and Measures Weights and Measures
•
National Institute of Standards and Technology Handbook 44 Class III and IIIL
•
Consumer and Corporate Affairs Canada Weights and Measures Act and Regula-
tions general class.
Safety Safety Safety Safety Safety
•
Underwriters Laboratory 114 and 466
•
Canadian Standards Association C22.2 No. 151-m1986
•
National Electrical Manufacturers Association Standard 250 Type 4 (NEMA 4)
•
International Electrotechnical Commission Pub. 529 Index of Protection 65-(IP65)
•
DIN VDE 0411
LEGAL FOR TRADE NOTE LEGAL FOR TRADE NOTE LEGAL FOR TRADE NOTE LEGAL FOR TRADE NOTE LEGAL FOR TRADE NOTE
Throughout this manual, the abbreviation “LFT” represents “Legal For Trade”.