Ohaus I150-S Indicator - Manual (Page 31)

31
Average Display Cycle Average Display Cycle Average Display Cycle Average Display Cycle Average Display Cycle
Average display cycle is used for animal
weighing where the movement of animal
subjects on the load receiver causes in-
stability and inaccurate weight measure-
ments. Using this feature, you can enter
a number of sample readings (from 1 to
255) which the indicator will average be-
fore displaying a weight measurement.
Entering 1 for this parameter disables the
feature.
Enter the number of readings to be
averaged using the numeric keypad,
then press ENTER to return to scale
submenu.
Refer to “Animal Weighing” in the OP-
ERATION section for the animal weighing
procedure.
LFT NOTE: LFT NOTE: LFT NOTE: LFT NOTE: LFT NOTE: Does not appear on menu
when LFT is set to ON.
Parts Count Error Level Parts Count Error Level Parts Count Error Level Parts Count Error Level Parts Count Error Level
The parts counting function of the I150
assumes that all parts are of a reasonably
uniform weight. Since there is usually
some difference, an allowable percent-
age of error can be entered. The error is
a percentage of the sample part(s) weight.
Acceptable entries can be from:
50
__________ % to 100%
resolution
To enter a parts counting error level:
Enter the desired error using the
numeric keypad,
then press ENTER to return to scale
submenu
LFT NOTE: LFT NOTE: LFT NOTE: LFT NOTE: LFT NOTE: Does not appear on menu
when LFT is set to ON.
ENTER ENTER ENTER ENTER ENTER
ENTER ENTER ENTER ENTER ENTER