Ohaus I150-S Indicator - Manual (Page 25)

25
Reset to Factory Defaults Reset to Factory Defaults Reset to Factory Defaults Reset to Factory Defaults Reset to Factory Defaults
This parameter is used to reset all scale
submenu parameters to the factory de-
fault settings outlined in the following table.
To reset to the factory defaults,
press ENTER when “rESEt” is displayed.
Averaging Level Averaging Level Averaging Level Averaging Level Averaging Level
Averaging level compensates for vibra-
tion or excessive air currents on the load
receiver. During operation the I150 con-
tinually takes weight readings from the
load cell. Successive readings are then
averaged to achieve a stabilized display.
This parameter specifies whether the I150
will average more or fewer successive
readings. Select one of four averaging
levels.
To select an averaging level:
Enter the desired level (0, 1, 2, or 3)
using the numeric keypad, then press
ENTER to return to the scale sub-
menu.
Minimum
Averaging
Maximum
Averaging
PARAMETER LFT = OFF LFT = ON
(Menu changes (Menu changes
disabled w/jumper) enabled)
Averaging Level 3 3 3
Stability Range 0.5 grad unchanged 0.5 grad
Unit Selection all units = ON lb, kg = ON lb, kg = ON
Auto Zero Tracking 0.5 grad unchanged 0.5 grad
Custom Unit Exponent 0 N/A N/A
Custom Unit Mantissa 1.0 N/A N/A
Average Display 1 N/A N/A
PC Error Level 100% N/A N/A
Set Point OFF OFF OFF
Store Tare Tare Tare
Retain OFF OFF OFF
ENTER ENTER ENTER ENTER ENTER
ENTER ENTER ENTER ENTER ENTER