Parts counting – Ohaus I150-S Indicator User Manual

Page 52

Parts Counting

Parts counting enables you to place a
batch of similar parts on the platform
while the indicator displays the total num-
ber of parts. To use this function, the parts
must be reasonably uniform in weight.
The accuracy of your results will be deter-
mined by the error level that was entered
in “PC Err” of the scale submenu.

LFT NOTE:

LFT NOTE: This feature is not available
when LFT is set to ON.

A press-on label (“PCS”) for parts count-
ing is included in the accessory kit. It
should be affixed to the blank button next
to the FUNCTION button on the keypad.

The following procedure assumes that a
container of some sort will be used to hold
the parts. If this is not the case, simply
ignore step 1.

Place an empty container on the load

receiver and press

TARE

to tare the

weight of the container, or

if the empty container weight is known,

enter the weight using the numeric

keypad, then press

TARE

If the average piece weight of a single

part is known, enter the weight using

the numeric keypad, press

FUNC

then press

PCSS

and proceed to

step 4.

If the average piece weight is un-
known, place a sample number of
pieces in the container or on the load
receiver.

Enter container tare

weight if known.

Enter average piece

weight if known.

TARE

FUNCTION

APW

PCS