Ohaus I150-S Indicator - Manual (Page 21)

21
Calibration Unit Calibration Unit Calibration Unit Calibration Unit Calibration Unit
The indicator can be calibrated using
pounds or kilograms; no other units are
acceptable. If dual load receivers are
used, the same calibration unit applies to
both.
When you access this parameter, the
display will show the word “Unit” and the
current calibration unit indicator.
To change the calibration unit:
Press UPUP or DOWN to switch to
the desired unit, then press ENTER
to return to the setup submenu
RECALIBRATION IS REQUIRED RECALIBRATION IS REQUIRED RECALIBRATION IS REQUIRED RECALIBRATION IS REQUIRED RECALIBRATION IS REQUIRED if the
calibration unit is changed. Setup sub-
menu changes are not saved if you exit
menus without recalibrating.
Full Scale Point Full Scale Point Full Scale Point Full Scale Point Full Scale Point
The maximum capacity of the load re-
ceiver is entered in this parameter using
the same weighing unit selected for the
calibration unit.
To enter the full scale point:
Enter the number using the numeric
keypad, then press ENTER to return
to the setup submenu.
RECALIBRATION IS REQUIRED RECALIBRATION IS REQUIRED RECALIBRATION IS REQUIRED RECALIBRATION IS REQUIRED RECALIBRATION IS REQUIRED if the
full scale point is changed. Setup sub-
menu changes are not saved if you exit
menus without recalibrating.
LFT NOTE: LFT NOTE: LFT NOTE: LFT NOTE: LFT NOTE: Resolution is limited to
1:10,000 for Legal for Trade installations.
Enter Full Scale Point
ENTER ENTER ENTER ENTER ENTER
ENTER ENTER ENTER ENTER ENTER