Ohaus I150-S Indicator - Manual (Page 28)

28
Auto-Zero Tracking Auto-Zero Tracking Auto-Zero Tracking Auto-Zero Tracking Auto-Zero Tracking
Auto-Zero tracking minimizes the effects
of temperature changes and shift on the
zero reading. Using this parameter, you
select a threshold level (in graduations),
which the I150 will consider to be a valid
change in load. Selections are .5, 1, and
3 graduations. OFF disables the feature.
To select a value or disable the feature:
Press UPUP or DOWN to display the
desired selection, then press ENTER
to return to the scale submenu.
LFT NOTE: LFT NOTE: LFT NOTE: LFT NOTE: LFT NOTE: Initially set to .5 when LFT is
set to ON. May be changed to 1 or 3 for
special applications: Normally set to .5 for
bench and counter scales; 3 for vehicle
scales; 1 for other scales.
Custom Unit Conversion Custom Unit Conversion Custom Unit Conversion Custom Unit Conversion Custom Unit Conversion
Factor Factor Factor Factor Factor
If you need to display weight measure-
ments in a unit other than LB, KG or OZ,
this feature enables you to create your
own unit of measure. You enter a conver-
sion factor which the indicator will use to
convert the calibration unit to the desired
unit of measure. There are two examples
at the end of this section which illustrate
how to determine conversion factors.
Once your conversion factor is deter-
mined, use the following procedure to
enter it.
LFT NOTE: LFT NOTE: LFT NOTE: LFT NOTE: LFT NOTE: Not available when LFT is set
to ON.
ENTER ENTER ENTER ENTER ENTER