Print stable data only print block or display data, Print stable data only, Print block or display data – Ohaus I150-S Indicator User Manual
Page 44
44
11. Enter the desired interval in seconds
( maximum of 255) using the numeric
keypad, then press
ENTR
.
12. Press
UPUP
or
DOWN
to scroll to
“End”.
13. Press
ENTER
to exit “Init” and return
to the rS-232 submenu.
LFT NOTE:
LFT NOTE:
LFT NOTE:
LFT NOTE:
LFT NOTE: This feature is disabled when
LFT is set to ON.
Print Stable Data Only
Print Stable Data Only
Print Stable Data Only
Print Stable Data Only
Print Stable Data Only
When enabled, this parameter allows only
stable display data to be printed.
To set this feature ON or OFF:
Press
UPUP
or
DOWN
to display the
desired setting, then press
ENTER
to return to the rs232 submenu.
LFT NOTE:
LFT NOTE:
LFT NOTE:
LFT NOTE:
LFT NOTE: This parameter is automati-
cally ON when LFT is set to ON.
Print Block or Display Data
Print Block or Display Data
Print Block or Display Data
Print Block or Display Data
Print Block or Display Data
“Print” enables you to select displayed
data or block data for RS232 output.
Selecting display print causes displayed
data (full or numeric data only) to be
output. Selecting block print causes the
following information to be output:
For Weighing:
For Weighing:
For Weighing:
For Weighing:
For Weighing: Gross, Net and Tare
For Parts
For Parts
For Parts
For Parts
For Parts
# Pieces, Avg. Piece Wt.,
Counting:
Counting:
Counting:
Counting:
Counting:
Gross, Net and Tare
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER