Finishing tab in the job parameters window – Xerox CX PRINT SERVER 560 User Manual
Page 116

Finishing tab in the job parameters window
Apply these settings to specify how to finish your job.
Parameter
Option
Description
Finishing
Output tray
Lists the available finisher options. This list depends on the
modules that are installed on the printer.
Provides the following options:
●
OCT
●
SCT
●
Standard Top Tray
●
Standard Stacker Tray
●
Booklet Maker Tray
●
Standard Trifold Tray
●
Advanced Top Tray
●
Advanced Stacker Tray
●
Professional Top Tray
●
Professsional Trifold Tray
●
Professional Booklet Maker Tray
OCT (Offset catch
tray)
Provides the following option:
Specify when to offset copies of your job. The default is set
to 1. If you do not want to use an offset between sets, clear
this check box.
Note: If the page size is larger than A3 (standard or
custom), the Offset check box is not available.
SCT (Standard
catch tray)
Standard output tray with no finishing options available.
Standard Top Tray
Provides the following options:
●
Punch—The values vary according to the type of punch
unit connected. The number of holes is 2.
●
Z-Fold half sheet
Standard Stacker
Tray
Provides the following options:
●
Staples—The position of the staples on the page.
●
Punch—The values vary according to the type of punch
unit connected. The number of holes is 2.
●
Z-Fold half sheet
Booklet Maker
Tray
Provides the following options:
●
Booklet Staple
Standard TriFold
Tray
Provides the following options:
●
Tri-fold Z
●
Tri-fold C
106
Chapter 11—Job parameters