beautypg.com

Deleting certain parameters from a scene, Permissn permissn allfader allfader – Zoom MRS-802 User Manual

Page 76

background image

Reference [Mixer]

ZOOM MRS-802

76

H

INT

To cancel a scene assignment, turn the dial to make the

display indicate “ -- “.

6.

Locate the next mark at which you want the mix to

change, and repeat steps 4 - 5.

7.

When scenes have been assigned to all marks,

press the ZERO [

U

] key to return to the beginning

of the song, and then press the PLAY [

R

] key to

start playback.

Each time the song reaches a mark to which a scene has been

assigned, that scene will be recalled.

Deleting certain parameters from a
scene

If desired, you can disable a group of parameters saved in a

scene. Such parameters will not change even if that scene is

recalled. The following groups of parameters can be

specified and made active or inactive.

For example, after you have programmed a sequence of

automatic scene changes, you may want to disable the

TRACK PARAMETER group and set only the EQ and

panning parameters manually for each track.

1.

Press the [SCENE] key in the control section, and

then press the [UTILITY] key in the display section.

The following screen appears on the display. In this

condition, you can enable or disable the faders for each

scene.

2.

Turn the dial to set fader permission to ON or OFF.

3.

Press the other keys for parameter groups, to

enable or disable the group.

Except for the fader, scene control for the other groups can

be enabled or disabled by pressing one of the keys listed

below.

• TRACK PARAMETER group

Any status key except [MASTER] status key

• INSERT EFFECT group

Any [INSERT EFFECT] key

• CHORUS/DELAY group

[CHORUS/DELAY] key

• REVERB group

[REVERB] key

When a group is enabled, the respective keys are lit, and

when the group is disabled, the keys are flashing.

H

INT

• The TRACK PARAMETER group can be enabled or

disabled for each audio track and the drum track

separately.

• You can also use the cursor up/down keys to enable or

disable all groups together.

4.

When the setting is complete, press the [EXIT] key.

The unit returns to the scene menu.

5.

To return to the main screen, press the [EXIT] key.

The parameter group on/off status is stored as part of the

project.

TRACK
PARAMETER

INSERT EFFECT

CHORUS/DELAY

REVERB

ALL FADER

EQ HI

EQ LO

Chorus send

Reverb send

Pan

Play/mute

Patch number

Input source

Patch number

Patch number

Fader position

Item

Group

Permissn

Permissn
AllFader

AllFader

ON