Zoom MRS-802 - Manual (Page 55)

Reference [Track Editing]
ZOOM MRS-802
55
Exchanging V-takes
You can exchange the audio data of two specified V-takes.
1.
Refer to steps 1 - 5 of “Basic V-take editing steps”
to select the exchange source track/V-take and to
bring up the indication “EXCHG” on the display.
Then press the [ENTER] key.
A screen for selecting the exchange destination appears on
the display.
2.
Use the cursor left/right keys and the dial to select
the exchange destination V-take, and press the
[ENTER] key.
The indication “EXCHG SURE?” appears on the display.
3.
To execute the exchange operation, press the
[ENTER] key once more. To cancel the operation,
press the [EXIT] key.
After the exchange operation is completed, the unit returns
to the V-take editing menu.
Track capture and swap
You can capture the audio data of any track and temporarily
store them on the hard disk. Later you can swap the captured
data with the current data of the track. This lets you for
example save the state of a track before an editing operation.
If the result of the operation is not as desired, you can then
easily restore the track to its previous state.
N OTE
Captured track data will be erased from the hard disk when
the currently selected project is saved.
Capturing a track
You can capture the audio data of any specified track.
1.
From the main screen, press the [UTILITY] key in
the display section.
The indication “UTILITY TR EDIT” appears on the display.
2.
Use the cursor left/right keys to bring up the
indication “UTILITY CAP/SWAP” on the display,
and press the [ENTER] key.
Exchange
EXCHG TO EXCHG TO
TR 1- 1
TR 1- 1
Recorded data
Track 1
Track 2
Track 3
Captured data
of track 1
Capture operation
for track 1
Recorded data
Track 1
Track 2
Track 3
Captured data
of track 1
Swap operation
for track 1
◆ Capture
Recorder
Recorder
Track 1
Track 2
Track 3
Captured data
of track 1
Recorder
◆ Swap