Zoom MRS-802 - Manual (Page 38)

Reference [Recorder]
ZOOM MRS-802
38
2.
Use the cursor up/down keys to bring the
indication “TR XX-XX” onto the display (where X is
the track number and V-take number).
3.
Press the [MASTER] status key to select the
master track.
The number and name of the V-take currently selected for
the master track appear on the display. (If nothing is
recorded on the V-take, the indication shows “NO DATA”.)
H INT
Instead of pressing the [MASTER] status key, you can also
use the cursor left/right keys to select the master track.
4.
If you want to change the V-take, turn the dial.
5.
When the V-take has been selected, press the
[EXIT] key.
The [TRACK PARAMETER] key goes out, and the unit
returns to the main screen.
6.
From the main screen, press the [MASTER] status
key several times, until the key is lit in red.
The master track is now ready for recording.
While the key is lit in red, the other tracks as well as the
drum track and effects operate normally.
H INT
The signal recorded on the master track is the signal coming
from the [MASTER] fader. This is the same signal that is
supplied at the OUTPUT jacks.
7.
Set the recorder to playback and adjust the mixing
balance of the various tracks.
The individual track level settings as well as the insert effect
and send/return effect settings all have an influence on the
signal that is sent to the master track. Adjust levels while
watching the L/R level meter, and make sure that no signal
clipping occurs.
8.
To carry out the mixdown operation, press the
ZERO [ U ] key to return to the beginning of the
song, and then press the PLAY [ R ] key while
holding down the REC [ O ] key.
Recording on the master track starts.
9.
When recording is complete, press the STOP [ P ]
key.
Playing the master track
To play the recorded master track, proceed as follows.
1.
From the main screen, press the [MASTER] status
key several times, until the key is lit in green.
The unit goes into master track playback mode. In this
mode, all other status keys are out, all other tracks are
muted, and all effects are switched off.
H INT
While the [MASTER] status key is lit in green, the transport
keys except for the REC [ O ] key operate normally.
2.
Press the ZERO [ U ] key to return to the beginning
of the song, and then press the PLAY [ R ] key.
Playback of the master track starts from the beginning. You
can use the [MASTER] fader to adjust the playback volume.
TR 2- 1 TR 2- 1
GTR 2- 1
GTR 2- 1
TR M- 1 TR M- 1
NO DATA
NO DATA
Master track