Zoom MRS-802 - Manual (Page 147)

Appendix
ZOOM MRS-802
147
● VOL PDL module
Parameter Description
● MODULATION/DELAY module
Parameter Description
Type Parameter
VOL PDL
MIN VOL
You can use an expression pedal to control the volume.
Parameter Name Setting Range Parameter Description
MIN VOL 0 – 10
When using an expression pedal as a volume pedal, this parameter specifies the
minimum volume.
Type Parameter
CHORUS
DEPTH RATE MIX
Stereo chorus with clear sound and great spaciousness.
FLANGER
DEPTH RATE FB
An effect that adds a pronounced character and modulation to the sound.
PHASER
POSITION RATE COLOR
An effect that adds a swooshing modulation to the sound.
TREMOLO
DEPTH RATE CLIP
An effect that cyclically varies the volume.
PDL-WAH
POSITION FREQ LEVEL RTM
An effect that lets you use an expression pedal to control wah manually.
AutoWah
FLT TYPE POSITION RESO SENS
An effect in which wah is applied according to your playing dynamics.
PITCH
SHIFT TONE BALANCE
An effect that modifies the pitch of the direct sound.
RingMod
POSITION RATE BALANCE
An effect that produces a metallic resonance.
EXCITER
FREQ DEPTH LowBoost
An effect that gives the sound more focus and spatial definition.
AIR
SIZE TONE MIX
Simulates the effect of air on the room resonance, giving the sound spatial depth.
WIDE
TIME WET LVL DRY LVL
An effect that produces the sound of a stereo recording made with two mics.
DELAY
TIME FB MIX
A delay effect with a maximum of 500 ms.
Parameter Name Setting Range Parameter Description
DEPTH 0 – 10 Adjusts the depth of the effect.
RATE 1 – 30 Adjusts the speed of the effect.
MIX 0 – 30 Adjusts the mix amount of the effect.
FB
TYPE = FLANGER : -10 – 10
Adjusts the amount of feedback.
TYPE = DELAY : 0 – 10
POSITION AF / bF
Exchanges the effect locations of the PREAMP/DRIVE module and
MODULATION/DELAY module.
COLOR 1 – 4 Specifies the type of phase tone.
CLIP 0 – 10 Emphasizes the effect.
FREQ
TYPE = PDL-WAH : 1 – 50 Adjusts the wah center frequency.
TYPE = EXCITER : 1 – 5
Adjusts the frequency.
LEVEL 1 – 8
RTM OFF / On Adjusts the module output level.
FLT TYPE bPF / LPF Specifies whether the expression pedal will be used as a wah pedal.
RESO 1 – 10 Specifies the type of filter.
SENS -10 – 10 Adds character to the sound.
SHIFT -12.0 – 24.0 Adjusts the sensitivity with which the effect is applied.
TONE 0 – 10 Adjusts the amount of shift produced by the pitch shifter.
BALANCE 0 – 30 Adjusts the tone.
LowBoost 0 – 10 Adjusts the balance between the direct sound and effect sound.
SIZE 1 – 10 Emphasizes the low-frequency range.
TIME
TYPE = WIDE : 1 – 64 Adjusts the spatial width.
TYPE = DELAY : 1 – 50 Adjusts the delay time.
WET LVL 0 – 30 Adjusts the mix amount of the effect sound.
DRY LVL 0 – 30 Adjusts the mix amount of the direct sound.