Zoom MRS-802 - Manual (Page 116)

Reference [Creating a CD]
ZOOM MRS-802
116
(3) Finalize status
When a “*” symbol is shown here, a non-finalized CD-R/
RW disc has been inserted.
(4) Current position in track
The location in the current track is shown here in hours (H),
minutes (M), and seconds (S).
5.
Use the FF [ Y ] and REW [ T ] keys to select the
track to be played.
While the track number is shown, the FF [
Y
] and REW
[ T ] keys can be used to select the track on the CD. The FF
[ Y ] key selects the next track and the REW [ T ] key selects
the previous track.
6.
Use the cursor up/down keys to select the
playback method for the audio CD.
Each push of the cursor up/down keys toggles between the
following two methods.
• D (Digital playback)
The digital audio signal of the CD is read by the MRS-802
in the digital domain and becomes available as an audio
signal at the rear panel MASTER OUTPUT jacks, and front
panel MASTER PHONES jack. (Default setting)
• A (Analog playback)
The audio signal of the CD is reproduced via the headphone
output of the CD-R/RW drive.
7.
To start playback of the audio CD, press the PLAY
[ R ] key.
Playback of the selected track starts. When the track is
finished, playback continues with the next track. During
audio CD playback, all faders except for the [MASTER]
fader as well as the EQ, reverb, chorus/delay, and pan
settings are disabled.
8.
For track selection and for controlling playback
stop/pause, use the transport section keys.
PLAY [ R ] key
Playback of the selected track starts. Pressing the key during
playback sets the system to pause mode.
STOP [ P ] key
Playback stops, and the system returns to the beginning of
the current track.
FF [ Y ] key
Playback stops, and the system jumps to the beginning of
the next track.
REW [ T ] key
Playback stops, and the system jumps to the beginning of
the current track.
9.
To return to the main screen, press the [EXIT] key
several times.