beautypg.com

Loading a project from cd-r/rw disc – Zoom MRS-802 User Manual

Page 122

background image

Reference [Creating a CD]

ZOOM MRS-802

122

is finished, the display indication changes to “ALL SAVE

COMPLETE”.

N

OTE

When a full backup spans several discs, restoring a single

project requires you to first insert the disc on which it is

saved. Be sure to note the disc number and the projects

saved on the disc on the case and label of the disc.

H

INT

When the disc has been ejected, it also possible to abort the

backup operation. To do this, press the [EXIT] key while the

indication “CHANGE DISCxxx” (where xxx is the disc

number) is shown. The indication will change to “ALL SAVE

CANCEL?”. Press the [ENTER] key to terminate the process.

8.

To return to the main screen, press the [EXIT] key

several times.

Loading a project from CD-R/RW disc

To restore a project saved on CD-R/RW disc to the hard disk

of the MRS-802, proceed as follows.

1.

From the main screen, press the [CD-R/RW] key in

the display section.

The CD-R/RW menu appears.

2.

Use the cursor left/right keys to bring up the

indication “CD-R/RW BACKUP” on the display, and

press the [ENTER] key.

The display shows the backup/restore menu.

3.

Use the cursor left/right keys to bring up the

indication “BACKUP LOAD” on the display, and

press the [ENTER] key.

The indication “LOAD InsDisc1” appears on the display.

4.

Insert the CD-R or CD-RW where the project is

saved into the CD-R/RW drive.

• If project was backed up as single project

Insert disc number 1.

• If project was backed up as part of a full backup of all

projects

Insert the disc where the project is stored. (If there are

multiple discs, insert the first disc that contains data of the

desired project.)

N

OTE

• Also when you have backed up all projects in a single

operation, restore is performed for single projects.

• If the backup of the project spans multiple discs, be sure

to insert the first disc that contains data of the desired

project first. If you insert another disc, the project data will

not be read correctly.

5.

Press the [ENTER] key.

The name of the project on the disc, and the number which is

to be assigned to the project are shown on the display.

H

INT

When being restored to the MRS-802, an empty project

number is automatically assigned to the project. Even if a

project with the same name already exists on the hard disk,

it will not be overwritten.

6.

To check the name of the directory from which the

project will be read, press the cursor down button.

The display shows the directory name.

Press the cursor up key to restore the original display.

BACKUP

BACKUP
SAVE

SAVE

LOAD

LOAD
InsDisc1

InsDisc1

LOAD

LOAD
PRJ012

PRJ012

7

Project number

to be assigned

Project name

DirName

DirName
PROJ012

PROJ012

7

Directory name