ZyXEL Communications ZyXEL Dimension ES-2024PWR - Manual (Page 63)

Ethernet Switch CLI Reference Guide
63
C
H A P T E R
11
Cluster Commands
Use these commands to configure cluster management.
11.1 Command Summary
The following section lists the commands for this feature.
Table 33 cluster Command Summary
COMMAND DESCRIPTION M P
show cluster Displays cluster management status. E 3
cluster <vlan-id> Enables clustering in the specified VLAN group. C 13
no cluster Disables cluster management on the Switch. C 13
cluster name <cluster name> Sets a descriptive name for the cluster.
<cluster name>: You may use up to 32 printable
characters (spaces are allowed).
C 13
show cluster candidates Displays the switches that are potential cluster members. The
switches must be directly connected.
E 3
cluster member <mac> password
<password> Adds the specified device to the cluster. You have to specify
the password of the device too.
C 13
show cluster member Displays the cluster member(s) and their running status. E 3
show cluster member config Displays the current cluster member(s). E 3
show cluster member mac <mac> Displays the running status of the cluster member(s). E 3
cluster rcommand <mac> Logs into the CLI of the specified cluster member. C 13
no cluster member <mac> Removes the cluster member. C 13